Purpose Profiles

Spacers are usually made of galvanized steel. As the fixing material use, primarily, screws and plastic anchors, with increased tension can be used metal dowels with spacers and connecting screws. Can also use a thin (non-splitting tree) nails with a galvanized surface, and for concealed mounting Sc. "Black" nails. The shape of connecting nozzles made of galvanized steel sheet, adapted to the staffs of different types and sizes of grooves on the panels. Connecting profiles, which the panel attached to the wall or sshivnoy rail made of metal or plastic. Outdoor, anodized part aluminum profiles, as well as the color of plastic profiles emphasize the structure and nuances of the panels. Outer side of a metal or plastic profile can also cover the film "under the tree." Facing materials Purpose of covering materials, regardless of whether they are timber or a synthetic film, always is to emphasize the natural beauty of wood.

Sawn wood profiles most cases them only to "pass" through the sanding belt sanders. At these veneers drawing streaks and marks from the saw provide a comprehensive picture of the aesthetic. Planing wood Facing, profiles are made from top-notch choice of coniferous hardwood (oak, beech), from fruit trees (pear, walnut), exotic (tropical) species. The most commonly used high-grade conifers. Making repairs to turn-key apartment or house with a shell of solid wood, it is necessary to check sheathing material and to determine the functional purpose of this room, because in areas where there are drafts, and especially in wet areas (such as in baths), due to further deformation of the wood paneling impractical to install hardwood. With exotic breeds such problems do not arise, for example, mahogany can be used anywhere.

Width of the profiles of conifers, primarily depends on the requirements for plating. The word "width" should be understood the size of the rectangle to cut the profile, since it is on it manifest shrinkage and warping. Most-width 50 100 mm and thickness 12 18 mm. On a broader profile in order to relieve tension normally v-groove or recess or cut out the notch. However, in determining the depth of the groove should not only consider the reduction of torsional stress, but also so-called. reducing the size of the shrinkage, as a result of shrinkage or moisture absorption of resizing the tree can reach 10%. Profiled rail can only be done from a dry tree, and after production profile can be stored only in areas where there is no draft. Before mounting the appropriate at least once primed it. Known Several technologies veneer wood paneling in the case of euro-repair: for example, panels on the frame, pressed panels and panels with film coating. The panels on the frame are available in high quality category of "furniture board", they assembled at the job site. The frame is made of wood, and liners collected from the particle boards of softwood, hardwood or laminate boards. Surface tiles made from wood chips, either before or after making profile covers veneered furniture or film. The second option is rarely used, but the edges of plates are often covered with foil. Material from which is the supporting structure facing panels can be: wood chips, wood fiber hemp fire polystyrene plate (in recent years). The panel is glued outer layer thickness of 0,3 -1 mm. The overall panel thickness of 8-20 mm.