Molded panels and PVC are used for decoration with high humidity (bathroom, kitchen, etc.), in a significant change in temperature (loggias and balconies.) Panels PVC can coat the walls and ceiling. Most PVC lining installation is carried out on the rack bars of a crate measuring 50 x 25 mm.Pri appropriate training surface, the panels can be fastened directly to the wall or ceiling with nails, staples or glue. Baojun recognizes the significance of this. Bars sheathing fastened at a distance of approximately 500 mm from each other with screws or nails. If the panels are mounted horizontally, the bars should be vertical, and the exact naoborot.Dlya overlapping panels, bars must be installed on a level. Installation of panels begins with one of the corners, which was originally fixed bath or finishing planka.Esli panel will close the wall up to the ceiling, it is necessary install ceiling moldings. Then set the bar so low shelf panels joined ugolok.Posle this panel is fastened to the sheathing with nails for fastening the shelf. Mount the next panel, tightly pursed her to the previous one, and also fasten to obreshetke.Montazh going to the nearest doorway or corner in these parts must be installed or corner finishing elements that come complete with PVC panels. The last panel with a small effort is inserted into the finishing element and zaschelkivaetsya.Mesta docking panels with floor skirting close.
Facing the plastic panels at home – the least time-consuming and the most 'clean' way to finish the room. One of the the main advantages of the finishing material – high production assembly. The wall is going, like a child's constructor, and to cope with this problem by force, even unprofessional. Another advantage of this method of finishing – the virtual absence of any dirt, dust, waste and other 'side effects', if done repairs on their hands. Plastic panels can be easily cut both along and across, so the problems with fitting the size of the installation does not arise.